What's is the proper fastener to use to join two wires.

A. wire nut

B. cellophane tape

C. Spring clip

D. Staples

An A-26C aircraft has 2 piston engines driving propellers. It is climbing at a flight-path angle of 10 degrees. The aircraft weighs 32,000 pounds (142,343 Newtons).

For problems 1 and 2, six luminaires, similar to Style E used in the Commercial Building, are to be installed in a room that is 12 ft * 18 ft (∼3.7 m * ∼5.5 m) with a 9 ft (2.8 m) floor-to-ceiling height. The spacing ratio for the luminaire is 1:0.

Can someone draw a electric circuit with electrical symbols for this "In the hall there is one light bulb that can be turned on and off at both ends of the room and an electric bell.

Suppose values is a sorted array of integers. Give pseudocode that describes how a new value can be inserted so that the resulting array stays sorted.

A copper-nickel alloy of composition 60 wt% Ni-40 wt% Cu is slowly heated from a temperature of 1250°C (2280 °F).

Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.

The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius

Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.

What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution

The controller can be considered the brain of closed loop system