Engineering

Rodrigo Nunez

7 July, 10:34

Why are dynamic heads greater than static heads?

1. Because static suction lifts are limited in vertical lift

2. Because the friction losses are always greater than the

static heads

3. Because they are measured on the discharge side of the

pump

4. Because they include the static heads plus the friction

losses in the suction and discharge pipes

+2

Answers (1)

Know the Answer?

Not Sure About the Answer?

Get an answer to your question ✅ “Why are dynamic heads greater than static heads? 1. Because static suction lifts are limited in vertical lift 2. Because the friction ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.

Search for Other Answers

You Might be Interested in

The viscosity of a fluid determined by the Saybolt method can be found from two equations, the selection of which depends on the measured SSU. a) - True b) - False

If E = 94.2 mJ of energy is transferred when Q = 1.66 C of charge flows through a circuit element, what is the voltage across the circuit element?

The method Sum listed below returns the sum of integers between 1 and n. What is its order of growth? Create a new method that performs the same function that is a lower order of growth.

A gas flows through a one-inlet, one-exit control volume operating at steady state. Heat transfer at the rate takes place only at a location on the boundary where the temperature is Tb.

Nitrogen can be liquefied using a Joule-Thomson expansioni process. This is done by rapidlyl and adiabatically expandign cold nitrogen gas from high pressure to a low pressure. If nitrogen at 135 K and 20 MPa undergoes a Joule-Thomson expansion to 0.

New Questions in Engineering

Between 1975 and 1985, the volume of all iron and steel in a given automobile model decreased from 0.165 m3m3 to 0.118 m3m3. In the same time frame, the volume of all aluminum alloys increased from 0.012 m3m3 to 0.023 m3m3.

Which of the following is not an oxidizer? a) - H2O2 b) - CH c) - N2O4 d) - LO2

What are the basic steps in the operation of a solar cell?

What s the difference between buying a modded account or buying a booster for gta online

An exercise room has six weight-lifting machines that have no motors and seven treadmills, each equipped with a 2.5-hp (shaft output) motor. The motors operate at an average load factor of 0.7, at which their efficiency is 0.77.