Ask Question
EngineeringEngineering
14 September, 06:08

2D stress states can be suitable for analysis of aircraft structures. a) True b) False

+5
Answers (1)
  1. 14 September, 06:21
    0
    a) True

    Explanation:

    Yes we can say that 2D stress can be suitable for analysis of aircraft structures. We know that in general in air craft there are four forces these are thrust force, lift force and drag force due to air and force due to its weight.

    These all forces acting in one plane so we can say that this is 2D analysis of stress.
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “2D stress states can be suitable for analysis of aircraft structures. a) True b) False ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
to read the line voltage supplied to an appliance, you should connect the voltmeter a. in series with the power supply B. between the grounded wire and the water pipe C. across the power supply D. between terminals of two adjacent circuit parts
Answers (1)
How does the engine's crankshaft transmit energy to an automatic transmission? Group of answer choices Through the clutch Through the throw-out bearing Through the flex plate None of the answers listed
Answers (1)
Suppose a person (height of 1.8 m) walks in a room installed with a pyroelectric infrared (PIR) motion detector. The distance between the person and the PIR detector is 5 m. The PIR detector sensor is 3 cm x 1 cm in size.
Answers (1)
In plane stress, a prismatic bar of constant cross-section has an infinite length. a) True b) False
Answers (1)
A heat exchanger operates at steady state, and both flows through the exchanger are isobaric. Water flows through one side of the heat exchanger at 20 bar. The inlet temperature of the water is 280 Celsius. The outlet is saturated liquid.
Answers (1)
New Questions in Engineering
Roentgens are used to measure the amount of: uranium fuel burned radiation hydrogen isotopes
Answers (1)
What is the maximum % carbon for structural steel?
Answers (1)
An airplane flies from San Francisco to Washington DC at an air speed of 800 km/hr. Assume Washington is due east of San Francisco at a distance of 6000 km.
Answers (1)
An example of Ferrous alloy is Brass a) - True b) - False
Answers (1)
There is no difference in boring and drilling. a) - True b) - False
Answers (1)
Home » Engineering » 2D stress states can be suitable for analysis of aircraft structures. a) True b) False
Sign Up Forgot Password?