An insulated air nozzle with an inlet pressure of 10 bar operates with a mass flow rate of 1.2 kg s-1. The inlet temperature is 600 K and the outlet velocity is 100 m s-1. The inlet diameter is 0.5 m and the outlet diameter is 0.05 m. Determine the inlet velocity and the outlet temperature. What is the change in enthalpy across the nozzle? Assume air is an ideal gas. [0.95 m s-1, 595.2 K, - 5 kJ kg-1 ]
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “An insulated air nozzle with an inlet pressure of 10 bar operates with a mass flow rate of 1.2 kg s-1. The inlet temperature is 600 K and ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
An A-26C aircraft has 2 piston engines driving propellers. It is climbing at a flight-path angle of 10 degrees. The aircraft weighs 32,000 pounds (142,343 Newtons).
Answers (1)
For problems 1 and 2, six luminaires, similar to Style E used in the Commercial Building, are to be installed in a room that is 12 ft * 18 ft (∼3.7 m * ∼5.5 m) with a 9 ft (2.8 m) floor-to-ceiling height. The spacing ratio for the luminaire is 1:0.
Answers (1)
Can someone draw a electric circuit with electrical symbols for this "In the hall there is one light bulb that can be turned on and off at both ends of the room and an electric bell.
Answers (2)
Suppose values is a sorted array of integers. Give pseudocode that describes how a new value can be inserted so that the resulting array stays sorted.
Answers (1)
A copper-nickel alloy of composition 60 wt% Ni-40 wt% Cu is slowly heated from a temperature of 1250°C (2280 °F).
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)