Unwanted resistance is being discussed.
Technician A says that unwanted resistance can be caused by a loose ground connectic
Technician B says that unwanted resistance can be caused by corrosion at a connectior
Who is correct?
a. Technician A
c. Both Technician A and B
b. Technician B
d. Neither Technician A nor Technician B
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Unwanted resistance is being discussed. Technician A says that unwanted resistance can be caused by a loose ground connectic Technician B ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Which of these is least likely a step in replacing a failed compressor? A. Flushing the system B. Disconnecting and sealing the hoses C. Replacing the condenser D. Inspecting the muffler
Answers (1)
A deep drawing operation is performed on a sheet-metal blank that is 1/8 in thick. The height of the cup = 3.8 in and its diameter = 5.0 in (both inside dimensions).
Answers (1)
Write a program that displays the first 50 prime numbers in ascending order. Use a generic queue given below to store the prime numbers. Also, use the given method isPrime () to determine whether the number is prime or not.
Answers (1)
18. Which form records details of notable activities at any ICS level, including single resources, equipment, and task forces? FEN ruct O A. ICS-214: Activity Log O B. ICS-211: Incident Check-In List O C. ICS-202: Incident Objectives O D.
Answers (1)
If the current through a resistor is increased by a factor of 4, by what factor does the voltage change?
Answers (1)
New Questions in Engineering
16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.
Answers (1)
The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder
Answers (1)
What factors are likely to promote the formation of stress corrosion cracks?
Answers (1)
Find the mass if the force is 18 N and the acceleration is 2 m/s2
Answers (2)
Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion
Answers (1)