Sign In
Ask Question
Engineering
Zachariah Jacobson
24 August, 17:01
What are the two reasons for a clear cut
+4
Answers (
1
)
Reece Cowan
24 August, 19:07
0
to clear land for agriculture and settlement and to use or sell timber for lumber, paper products, or fuel.
Comment
Complaint
Link
Know the Answer?
Answer
Not Sure About the Answer?
Get an answer to your question ✅
“What are the two reasons for a clear cut ...”
in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
To increase fault-tolerance, the security administrator for Corp has installed an active/passive firewall cluster where the second firewall is held in reserve in case of primary firewall failure.
Answers (1)
the frequencies 10, 12, 23 and 45 Hz. (a) What is the minimum sampling rate required to avoid aliasing? (b) If you sample at 40 sps, which frequency components will be aliased?
Answers (1)
There are 20 forging presses in the forge shop of a small company. The shop produces batches of forgings requiring a setup time of 3.0 hours for each production batch.
Answers (1)
Write the equation for the output voltage as a function of the input voltage (sketch a circuit defining your variables). The maximum current coming out/into the op-amp output (terminal 6) is approximately 20 mA.
Answers (1)
5) A wire resistor of 1 mm diameter is in an ambient with T[infinity] = 33°C and h = 500 W/m2·K. The electrical resistance per unit length of wire is 0.01 Ω/m.
Answers (1)
New Questions in Engineering
Roentgens are used to measure the amount of: uranium fuel burned radiation hydrogen isotopes
Answers (1)
What is the maximum % carbon for structural steel?
Answers (1)
An airplane flies from San Francisco to Washington DC at an air speed of 800 km/hr. Assume Washington is due east of San Francisco at a distance of 6000 km.
Answers (1)
An example of Ferrous alloy is Brass a) - True b) - False
Answers (1)
There is no difference in boring and drilling. a) - True b) - False
Answers (1)
Home
»
Engineering
» What are the two reasons for a clear cut
Sign In
Sign Up
Forgot Password?