consider a packed bed of 10cm diameter concrte (stone mix) spheres to be used as a thermal (energy) storage sysytem initailly the speheres are 15 deg C; airat 50deg C flows around each sphere providing a convection coefficeint of 10Wm^-2k^-1. What will be surface temperature of these spheres after 5 hours
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “consider a packed bed of 10cm diameter concrte (stone mix) spheres to be used as a thermal (energy) storage sysytem initailly the speheres ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
The yield strength of mild steel is 150 MPa for an average grain diameter of 0.038 mm; yield strength is 250 MPa for average grain diameter 0.009 mm. What is the yield strength for the same steel having an average grain diameter 0.
Answers (1)
The Reynolds number for flow over a fixed horizontal flat plate is constant throughout its length. a) True b) False
Answers (1)
Suppose there are 76 packets entering a queue at the same time. Each packet is of size 5 MiB. The link transmission rate is 2.1 Gbps. What is the queueing delay of packet number 48? (in milliseconds, rounded to one decimal place, e. g. 0.
Answers (1)
The convection heat transfer coefficient for a clothed person standing in moving air is expressed as h 5 14.8V0.69 for 0.15, V, 1.5 m/s, where V is the air velocity. For a person with a body surface area of 1.
Answers (1)
Select the most economical W section of 50ksi steel for a 40 ft simple beam that supports a service concentrated load PL=30k at the midspan is laterally unbraced except at its ends and center line.
Answers (1)
New Questions in Engineering
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
What is the main role of matrix in composites! a) - to transfer stress to the other phases b) - to protect phases from environment c) - to reduce the hardness d) - to enhance ductility
Answers (1)