Three turbine generators of 20 MW capacity are supplying a load of 48 MW and the load suddenly increases to 50 MW. Two of the units are set with a speed droop of 9% and speed adjustment of 6%. The third unit is operating at zero speed droop and zero speed adjustment. Determine the change in system frequency due to the sudden load change. What wi the speed change be if the load increases to 54 MW?
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Three turbine generators of 20 MW capacity are supplying a load of 48 MW and the load suddenly increases to 50 MW. Two of the units are set ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
2. Determine the surface area of a primary settling tank sized to handle a maximum hourly flow of 0.570 m3/s at an overflow rate of 60.0 m/d. If the effective tank depth is 3.0 m, what is the effective theoretical detention time
Answers (2)
25 An 8-bit computer uses 2's complement to store negative numbers. The range of numbers that can be stored in this computer is ... A) from - 256 to + 256 B) from - 127 to + 127 C) from - 255 to + 256 D) from - 128 to + 127 E) none of the above.
Answers (1)
Which of the following terms describes the amount of time that a vehicle can be operated with its headlights on before battery voltage drops to 10.5V? Group of answer choices ampere-hours rating wattage reserve capacity cold cranking amps
Answers (1)
A steam power plant with a power output of 101.393 MW consumes coal at a rate of 55,309.154 kg/h. If the heating value of 23,888.055 kJ/kg, determine the overall efficiency of this plant. in percent (%) with three decimals.
Answers (1)
Determine the amount of gamma and alpha phases in a 10-kg, 1060 steel casting as it is being cooled to the following temperatures: (a) 900°C; (b) 728°C; and (c) 726°C.
Answers (1)
New Questions in Engineering
16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.
Answers (1)
The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder
Answers (1)
What factors are likely to promote the formation of stress corrosion cracks?
Answers (1)
Find the mass if the force is 18 N and the acceleration is 2 m/s2
Answers (2)
Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion
Answers (1)