Air at a pressure of 1 atm and a temperature of 50 °C is in parallel flow over the top surface of a flat plate that is heated to a uniform temperature of 100 °C. The plate has a length of 0.20 m (in the flow direction) and a width of 0.10 m. The Reynolds number based on the plate length is 40,000.
a. What is the rate of heat transfer from the plate to the air?
b. If the free stream velocity of the air is doubled and the pressure is increased to 10 atm, what is the rate of heat transfer?
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Air at a pressure of 1 atm and a temperature of 50 °C is in parallel flow over the top surface of a flat plate that is heated to a uniform ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
What are the optical properties of steel
Answers (1)
Define the terms marker
Answers (1)
Refrigerant 134a enters a horizontal pipe operating at steady state at 40oC, 300 kPaand a velocity of 40 m/s. At the exit, the temperature is 50oC and the pressure is 240 kPa. The pipe diameter is 0.04 m.
Answers (1)
The force that you apply to a simple machine is called the answers effect work load output
Answers (1)
The velocity ratio of a chain drive is 10. The diameter of the input sheave is 38 cm and it is rotating at a speed of 22 rad⁄s. Find the diameter of the output sheave and its angular velocity.
Answers (1)
New Questions in Engineering
A paper clip is made of wire 0.75 mm in diameter. If the original material from which the wire is made is a rod 25 mm in diameter, calculate the longitudinal engineering and true strains that the wire has undergone during processing
Answers (1)
What is the magnitude of the maximum stress that exists at the tip of an internal crack having a radius of curvature of 5 * 10-4 mm (1.969 * 10-5 in.) and a crack length of 4.5 * 10-2 mm (1.772 * 10-3 in.
Answers (1)
What are the factors of production in business? Land, labor, and capital land, capital, and interest land, labor, and customer base capital, customer base, and interest
Answers (1)
The author claims that engineers should always have the final say and last word when it comes to setting safety standards. Select one True False
Answers (2)
A positive electric charge is moved at a constant speed between two locations in an electric field, with no work done by or against the field at any time during the motion This situation can occur only if the (A) charge is moved in the direction of
Answers (1)