Consider a classroom for 56 students and one instructor, each generating heat at a rate of 100 W. Lighting is provided by 18 fluorescent lightbulbs, 40 W each, and the ballasts consume an additional 10 percent. Determine the rate of internal heat generation in this classroom when it is fully occupied. The rate of internal heat generation in this classroom when it is fully occupied is W.
Answers (2)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Consider a classroom for 56 students and one instructor, each generating heat at a rate of 100 W. Lighting is provided by 18 fluorescent ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Passband to baseband conversion: Consider the following passband signal, ypt = V2sine (2t) cos (200mt). where sinc (t) = / frac{sin (/pi t) }{/pi t} is the sinc function.
Answers (1)
1. Which type of fit implies that a piece will never fit? a. interference fit b. construction fit c. transition fit d. impeding fit
Answers (1)
True False. First angle projection type used in United states.
Answers (1)
A waste treatment pond is 50m long and 25m wide, and has an average depth of 2m. The density of the waste is 75.3 lbm/ft3. Calculate the weight of the pond contents in lbf, using a single dimensional equation for your calculation.
Answers (1)
This is a multi-part question. Once an answer is submitted, you will be unable to return to this part As steam is slowly injected into a turbine, the angular acceleration of the rotor is observed to increase linearly with the time t Know that the
Answers (1)
New Questions in Engineering
16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.
Answers (1)
The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder
Answers (1)
What factors are likely to promote the formation of stress corrosion cracks?
Answers (1)
Find the mass if the force is 18 N and the acceleration is 2 m/s2
Answers (2)
Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion
Answers (1)