Tech A says never use a water hose to clean up dust after a repair. Tech B says never use a floor scrubber to clean up dust after repairs. Who is correct?

Which of the following is true about ideal standards? a. Ideal standards provide allowance for normal breakdowns and interruptions. b. Ideal standards can be achieved under efficient operating conditions. c.

Government actions can have positive or negative effects on business. true or false

Which of the following is not true about intrusion detection systems (motion detectors, vibration sensors, light beams) ? A. They require human responseB. They cause a lot of false alarmsC. They depend on a constant power supplyD. They are foolproof

Recall from an earlier lecture that the relationship between the current through an inductor and the voltage across it is given by What is the current through a 10 mH inductor if 1 V is applied across it for exactly 20 ms?

The minimum waste compaction ratio reported by the manufacturer of a high-pressure compaction machine is 8:1. What is the corresponding percent volume reduction of the waste

Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.

The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius

Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.

What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution

The controller can be considered the brain of closed loop system