Sign In
Ask Question
Engineering
Marcelo Wolfe
22 October, 21:05
Define full and partial well abandonment.
+4
Answers (
1
)
Abril Rios
22 October, 23:19
0
Partial and Fully abandonment of well is a term used for oil well
Explanation:
Full Abandonment - This condition is depend on economics of the oil well. when production from oil well is come to that level when operating cost become higher than operating income, then it is need to shut down the well fully to prevent further loss.
Partial Abandonment - in this condition only the base part of the well is neglect permanently and from the upper portion of the well sidetracked well is build to acquire new target.
Comment
Complaint
Link
Know the Answer?
Answer
Not Sure About the Answer?
Get an answer to your question ✅
“Define full and partial well abandonment. ...”
in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
What is an advantage of having two oxygen regulators on a machine-cutting torch? a. It allows the cutting pressure to be adjusted without affecting the torch flame. b. It makes it possible to change cylinders during a cut without stopping the cut. c.
Answers (1)
Define nonferrous metals and give several examples.
Answers (1)
As shown, a load of mass 10 kg is situated on a piston of diameter D1 = 140 mm. The piston rides on a reservoir of oil of depth h1 = 42 mm and specific gravity S = 0.8.
Answers (1)
Steam is to be condensed in the condenser of a steam power plant at a temperature of 50°C with cooling water from a nearby lake, which enters the tubes of the condenser at 18°C at a rate of 97 kg/s and leaves at 27°C.
Answers (1)
Rewrite the following nested if-else statement as a switch statement that accomplishes exactly the same thing. Assume that num is an integer variable that has been initialized, and that there are functions f1, f2, f3, and f4.
Answers (1)
New Questions in Engineering
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
What is the main role of matrix in composites! a) - to transfer stress to the other phases b) - to protect phases from environment c) - to reduce the hardness d) - to enhance ductility
Answers (1)
Home
»
Engineering
» Define full and partial well abandonment.
Sign In
Sign Up
Forgot Password?