Ask Question
EngineeringEngineering
22 November, 11:29

A gas flows through a one-inlet, one-exit control volume operating at steady state. Heat transfer at the rate takes place only at a location on the boundary where the temperature is Tb. For each of the following cases, determine whether the specific entropy of the gas at the exit is greater than, equal to, or less than the specific entropy of the gas at the inlet:

(a) No internal irreversibilities,

(b) no internal irreversibilities,

(c) no internal irreversibilities,

(d) internal irreversibilities,

(e) internal irreversibilities.

+2
Answers (1)
  1. 22 November, 14:23
    0
    (a) S₁-S₂ = 0 ⇒ S₁=S₂ (b) S₁-S₂<0 ⇒ S₁0 ⇒ S₁>S₂ (d) S₁-S₂>0 ⇒ S₁>S₂

    Explanation:

    Solution

    Now,

    From the entropy rate balance at steady state, the equation is stated below:

    Qcv = / Tb + m (S₁-S₂) + σcv = 0

    ΔS = Qcv/Tb + σcv

    So,

    S₁-S₂ = Qcv/mTb + σcv/m

    (a) No internal irreversibilities and Q cv = 0

    Now,

    If Qcv = 0, the and value of σcv = 0

    S₁-S₂ = (Qcv/mTb + σcv/m) = 0

    hence

    S₁-S₂ = 0 which is S₁=S₂

    (b) no internal irreversibilities, and Q cv <0

    If Q cv <0 the value becomes this,

    S₁-S₂ = (Qcv/mTb + σcv/m) <0

    So,

    S₁-S₂<0 which is S₁
    (c) no internal irreversibilities and Q cv >0

    If Q cv >0 the value is

    S₁-S₂ = (Qcv/mTb + σcv/m) >0

    So,

    S₁-S₂>0 which is S₁>S₂

    (d) internal irreversibilities and Qcv ≥ 0

    If Q cv ≥0 the value is

    S₁-S₂ = (Qcv/mTb + σcv/m) >0

    So,

    S₁-S₂>0 which is S₁>S₂

    Note: option (d) and (e) are the same
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “A gas flows through a one-inlet, one-exit control volume operating at steady state. Heat transfer at the rate takes place only at a ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
An A-26C aircraft has 2 piston engines driving propellers. It is climbing at a flight-path angle of 10 degrees. The aircraft weighs 32,000 pounds (142,343 Newtons).
Answers (1)
For problems 1 and 2, six luminaires, similar to Style E used in the Commercial Building, are to be installed in a room that is 12 ft * 18 ft (∼3.7 m * ∼5.5 m) with a 9 ft (2.8 m) floor-to-ceiling height. The spacing ratio for the luminaire is 1:0.
Answers (1)
Can someone draw a electric circuit with electrical symbols for this "In the hall there is one light bulb that can be turned on and off at both ends of the room and an electric bell.
Answers (2)
Suppose values is a sorted array of integers. Give pseudocode that describes how a new value can be inserted so that the resulting array stays sorted.
Answers (1)
A copper-nickel alloy of composition 60 wt% Ni-40 wt% Cu is slowly heated from a temperature of 1250°C (2280 °F).
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
Home » Engineering » A gas flows through a one-inlet, one-exit control volume operating at steady state. Heat transfer at the rate takes place only at a location on the boundary where the temperature is Tb.
Sign Up Forgot Password?