In ARQ, a NAK:
a. is sent by the recipient if the message was received without error
b. is sent by the sender at the same time as it sends a data packet
c. is sent by the recipient if the message contains an error refers to non-asynchronous
d. Kermit technique means that the sender should continue with sending the next message
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “In ARQ, a NAK: a. is sent by the recipient if the message was received without error b. is sent by the sender at the same time as it sends ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Which of the following is not true about intrusion detection systems (motion detectors, vibration sensors, light beams) ? A. They require human responseB. They cause a lot of false alarmsC. They depend on a constant power supplyD. They are foolproof
Answers (1)
Which of the sequences below represents the various steels types in order of decreasing hardness? a. High-carbon > Low-carbon > Medium-carbon b. Low-carbon > Medium-carbon > High-carbon c. High-carbon > Medium-carbon > Low-carbon d.
Answers (1)
Is the storage location for file
Answers (1)
Consider a 7-truss structure. The cross-section area of all horizontal and vertical trusses is 3 inch^2, while the diagonal trusses have a cross sectional area of 1 inch^2. The truss structure is steel (modulus is 30 Msi).
Answers (1)
A jet impinges directly on to a plate that is oriented normal to the axis of the jet. The mass flow rate of the jet is 50 kg/min and its velocity is 200 m/s. Perform a control volume analysis to calculate the force on the plate.
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)