Ask Question
EngineeringEngineering
13 March, 01:02

Which is/are not a mechanism commonly associated with tool wear (mark all that apply) ? a. Adhesion b. Attrition c. Abrasion d. Coercion

+1
Answers (1)
  1. 13 March, 01:45
    0
    Answer: d) Coercion

    Explanation:Tool wear is defined as the situation when the cutting tool is subjected to the regular process of cutting metal then they tend to wear because of the continuous action of cutting and facing stresses and pressure. The mechanism that does not happen during this process are coercion that means the process of exerting forces on any material forcefully against the will or need. Therefore, adhesion, attrition and abrasion are the process of tool wear. So the correct option is (d)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Which is/are not a mechanism commonly associated with tool wear (mark all that apply) ? a. Adhesion b. Attrition c. Abrasion d. Coercion ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Which of the following is not true about intrusion detection systems (motion detectors, vibration sensors, light beams) ? A. They require human responseB. They cause a lot of false alarmsC. They depend on a constant power supplyD. They are foolproof
Answers (1)
Which of the sequences below represents the various steels types in order of decreasing hardness? a. High-carbon > Low-carbon > Medium-carbon b. Low-carbon > Medium-carbon > High-carbon c. High-carbon > Medium-carbon > Low-carbon d.
Answers (1)
Is the storage location for file
Answers (1)
Consider a 7-truss structure. The cross-section area of all horizontal and vertical trusses is 3 inch^2, while the diagonal trusses have a cross sectional area of 1 inch^2. The truss structure is steel (modulus is 30 Msi).
Answers (1)
A jet impinges directly on to a plate that is oriented normal to the axis of the jet. The mass flow rate of the jet is 50 kg/min and its velocity is 200 m/s. Perform a control volume analysis to calculate the force on the plate.
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
Home » Engineering » Which is/are not a mechanism commonly associated with tool wear (mark all that apply) ? a. Adhesion b. Attrition c. Abrasion d. Coercion
Sign Up Forgot Password?