Ask Question
EngineeringEngineering
19 July, 20:46

List fabrication methods of composite Materials.

+3
Answers (1)
  1. 19 July, 23:10
    0
    Fabrication method of composite materials varies for one product of material to other product. It is basically developed to meet the product requirement.

    The fabrication of composite parts are depends upon different factors that are:

    Depend on the Characteristics of strengthening and matrices. The details of the product and the shape and size also. Application or end uses.

    Types of fabrication methodologies are:

    Press molding Compression molding Contact mold Open molding Tube rolling
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “List fabrication methods of composite Materials. ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
2. Similar to problem 1, assume your computer system has a 32-bit byte-addressable architecture where addresses and data are each 32 bits. It has a 16K-byte (16,384 bytes) direct-mapped cache, but now the block size is 32 bytes.
Answers (1)
If two statements are inconsistent with each other, at least one of them must be false. a) - True b) - False
Answers (1)
Refrigerant-134a enters a 28-cm-diameter pipe steadily at 200 kPa and 20°C with a velocity of 5.5 m/s. The refrigerant gains heat as it flows and leaves the pipe at 180 kPa and 40°C. The specific volumes of R-134a at the inlet and exit are 0.
Answers (1)
Twenty distinct cars park in the same parking lot every day. Ten of these cars are US-made, while the other ten are foreign-made. The parking lot has exactly twenty spaces, all in a row. so the cars park side by side.
Answers (1)
Which type of load generates a magnetic field?
Answers (1)
New Questions in Engineering
What is the definition of a fluid?
Answers (1)
You are ordering steel cable for a 250 foot long zip-line you are building in your back yard. The cable can be ordered in diameters with 1/16 inch increments. (1/16, 1/8, 3/16, 1/4, 5/16, 3/8, etc.
Answers (2)
Which of the following statements is LEAST-Likely true? A) Do not attempt to unseat the beads of an inflated tire. B) Do not strike the tire or rim with a hammer. C) A hammer is sometimes necessary when removing a passenger car tire.
Answers (1)
What is the pitch circle diameter of a 50-tooth spur gear having a circular pitch of 0.375 inch
Answers (1)
Emergency plans are being formulated so that rapid action can be taken in the event of an equipment failure. It is predicted that if a particular pipeline were to rupture, it would release ammonia at a rate of 100 lb/s.
Answers (1)
Home » Engineering » List fabrication methods of composite Materials.
Sign Up Forgot Password?