How do you make a 3d print

An inclined plane is a simple machine that can be described as a ramp. Group of answer choices True False

In a turning operation, spindle speed is set to provide a cutting speed of 1.8 m/s. The feed and depth of cut are 0.30 mm and 2.6 mm, respectively. The tool rake angle is 8°. After the cut, the deformed chip thickness is measured to be 0.49 mm.

For a DC coupled amplifier with a single high frequency pole, the phase of the gain approaches 90 degrees at frequencies well above the upper corner frequency. True or false?

Question 8 The property of a material by virtue of which abody returns to its original, shape after removal ofthe load is called O a. plasticity O b. elasticity O c. ductility O d. malleability O e. resilience

Air enters the combustor of a jet engine at p1=10 atm, T1=1000°R, and M1=0.2. Fuel is injected and burned, with a fuel/air mass ratio of 0.06. The heat released during combustion is 4.5 x 10^8 ft-lbf per slug of fuel (or 18,000 BTU/lbm). 1.

16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.

The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder

What factors are likely to promote the formation of stress corrosion cracks?

Find the mass if the force is 18 N and the acceleration is 2 m/s2

Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion