4. A certain tire has a size of P215/65R16. What does the 65 number signify?
A. The percentage of a tire's diameter to its circumference
OB. The Aspect Ratio of the tire
C. The Load Rating of the tire
he tire
OD. The percentage of a tire's size, from bead to bead, compared to its diameter
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “4. A certain tire has a size of P215/65R16. What does the 65 number signify? A. The percentage of a tire's diameter to its circumference ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
The basic concept of feedback control is that an error must exist before some corrective action can be made?
Answers (1)
Choose the correct statement. A. A firm's minimum efficient scale is the smallest quantity of output at which long-run average cost reaches its lowest level. B. A firm's minimum efficient scale increases when the number of people employed increases.
Answers (1)
The 0.5-kg collar C starts from rest at A and slides with negligible friction on the fixed rod in the vertical plane. Determine the velocity v with which the collar strikes end B when acted upon by the 5-N force, which is constant in direction.
Answers (1)
Beam carries loads that are parallel to ts longitudinal axis. a) - True b) - False
Answers (1)
The rate at which velocity changes is called?
Answers (2)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)