Technician A says a "dry park check" is a good way to check ball joints and control arm bushings for looseness. Technician B says that inner tie rod ends
can be most effectively checked for wear on an alignment rack with the vehicle's weight on the wheels and the locking pins removed from the turn
plates. Who is correct?
A. Technician A only
B. Technician B only
C. Both Technician A and B
D. Neither Technician A nor B
Answers (2)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Technician A says a "dry park check" is a good way to check ball joints and control arm bushings for looseness. Technician B says that ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
1. The type of ignition system in which two cylinders share one coil is called a: a. distributor ignition system. b. waste spark ignition system. c. coil-on plug ignition system. d. None of the above
Answers (1)
You want a pot of water to boil at 105celcius. How heavy a lid should you put on the 15 cm diameterpot when Patm = 101 kPa?
Answers (1)
Write down the duty of the Accumulators?
Answers (1)
A solid square rod is cantilevered at one end. The rod is 0.6 m long and supports a completely reversing transverse load at the other end of + / - 2 kN. The material is AISI 1080 hot-rolled steel.
Answers (1)
Which actions would the maintenance and operations crews carry out as a building is completed and preparing to open to the public? Select all that apply.
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)