Which statement describes a third class lever?
The fulcrum is between the input and output forces.
The input force is between the fulcrum and output force.
The input and output forces are equal distance from the fulcrum.
The output force is between the fulcrum and input force.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Which statement describes a third class lever? The fulcrum is between the input and output forces. The input force is between the fulcrum ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
What is the average speed of a car that travels 80km in 1.5 hours
Answers (2)
A technique for resolving complex repetitive waveforms into sine or cosine waves and a DC component is known as: (A) Fourier Analysis (B) Harmonic Analysis (C) Frequency Analysis (D) Armstrong's Principle
Answers (1)
A phone charger requires 0.5 A at 5V. It is connected to a transformer with 100 % of efficiency whose primary contains 2200 turns and is connected to 220-V household outlet.
Answers (1)
An employee's total weekly pay equals the hourly wage multiplied by the total number of regular hours plus any overtime pay. Overtime pay equals the total overtime hours multiplied by 1.5 times the hourly wage.
Answers (1)
The mechanical properties of a metal may be improved by incorporating fine particles of its oxide. Given that the moduli of elasticity of the metal and oxide are, respectively, 60 GPa and 380 GPa, what is the (a) upper-bound, and (b) lower-bound
Answers (1)
New Questions in Engineering
16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.
Answers (1)
The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder
Answers (1)
What factors are likely to promote the formation of stress corrosion cracks?
Answers (1)
Find the mass if the force is 18 N and the acceleration is 2 m/s2
Answers (2)
Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion
Answers (1)