A 100 kmol/h stream that is 97 mole% carbon tetrachloride (CCL) and 3% carbon disulfide (CS2) is to be recovered from the bottom of a distillation column. The feed to the column is 16 mole% CS2 and 84% CC14, and 2% of the CC14 entering the column is contained in the overhead stream leaving the top of the column. (a) Draw and label a flowchart of the process and do the degree-of-freedom analysis. (b) Calculate the mass and mole fractions of CCl4 in the overhead stream, and determine the molar flow rates of CCl4 and CS2 in the overhead and feed streams. (c) Suppose the overhead stream is analyzed and the mole fraction of CS2 is found to be significantly lower than the value calculated in Part (b). List as many reasons as you can for the discrepancy, including possible violations of assumptions made in Part (b).
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “A 100 kmol/h stream that is 97 mole% carbon tetrachloride (CCL) and 3% carbon disulfide (CS2) is to be recovered from the bottom of a ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Dave and Ellen are newly married and living in their first house. The yearly premium on their homeowner's insurance policy is $550 for the coverage they need.
Answers (1)
What measures can be taken to mitigate or prevent the formation of stress corrosion cracks?
Answers (1)
Am i stupid o dont really know
Answers (1)
A Pitot tube is mounted in the test section of a low-speed subsonic wind tunnel. The flow in the test section has a velocity, static pressure, and temperature of 150 mi/h, 1 atm, and 70∘F, respectively.
Answers (1)
Discuss the impact of the changing urban center. Include the impacts on political, economic, and social roles and opportunities. The changing role of the family and the diversity of class should also be introduced and discussed.
Answers (1)
New Questions in Engineering
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
What is the main role of matrix in composites! a) - to transfer stress to the other phases b) - to protect phases from environment c) - to reduce the hardness d) - to enhance ductility
Answers (1)