03-05 / Fig (3) Shows T-Section of dimension 10x10x2cm

10 cm

2 cm

10 cm

2 cm

A: Find the location of center of gravity (N. A) of the given T-Section

How do I calculate the gear ratio

Describe the process that you would use to hot forge an automotive connecting rod, indicating why each of the steps is used.

Assuming the temperature of the system is 20 C the atmospheric pressure is 0.998 atm, and the total volume collected in the balloon is 0.28 L, calculate the number of moles of H2 collected in the ballot. This is the actual yield.

Question 2 The ratio of lateral strain to the linear strain within elastic limit is known as Oa. Young's modulus O b. bulk modulus O c. modulus of rigidity O d. modulus of elasticity Oe. Poisson's ratio

What is the minimum hose diameter of an ideal vacuum cleaner that could lift a 14 kg dog off the floor?

16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.

The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder

What factors are likely to promote the formation of stress corrosion cracks?

Find the mass if the force is 18 N and the acceleration is 2 m/s2

Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion