Engineering

Gates

23 January, 15:33

The yield strength for an alloy that has an average grain diameter of 5.3 x 10-2 mm is 121 MPa. At a grain diameter of 8.0 x 10-3 mm, the yield strength increases to 233 MPa. At what grain diameter, in mm, will the yield strength be 209 MPa?

+5

Answers (1)

Know the Answer?

Not Sure About the Answer?

Get an answer to your question ✅ “The yield strength for an alloy that has an average grain diameter of 5.3 x 10-2 mm is 121 MPa. At a grain diameter of 8.0 x 10-3 mm, the ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.

Search for Other Answers

You Might be Interested in

True or False: Drag and tailwind are examples of a contact force. tyy guyss

03-05 / Fig (3) Shows T-Section of dimension 10x10x2cm 10 cm 2 cm 10 cm 2 cm A: Find the location of center of gravity (N. A) of the given T-Section

Millions of years ago, the Sierra Nevada region began to be uplifted along a crack in Earth's crust. The region on the other side of the crack moved downwards.

150 lb of force is applied at the end of a shaft that is 2 1/2 ft long. It is applied at an angle of 90° to the lever. How much torque is produced? If the shaft is rotating at 350 rpm, what is the power?

The inlet for a high-bypass-ratio turbofan engine has an area A1 of 6.0 m 2 and is designed to have an inlet Mach number M~ of 0.6. Determine the additive drag at the flight conditions of sea-level static test and Mach number of 0.

New Questions in Engineering

Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.

The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius

Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.

What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution

The controller can be considered the brain of closed loop system