Engineering

Miasy

19 August, 05:37

Technician A says that after replacing a power steering hose, the system should be flushed, refilled, and bled. Technician B says to replace any O-rings

when installing a new hose. Who is correct?

A. Technician A only

B. Technician B only

C. Both Technician

A and B

D. Neither Technician

A nor B

+4

Answers (1)

Know the Answer?

Not Sure About the Answer?

Get an answer to your question ✅ “Technician A says that after replacing a power steering hose, the system should be flushed, refilled, and bled. Technician B says to ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.

Search for Other Answers

You Might be Interested in

A closed, rigid tank fitted with a paddle wheel contains 2.0 kg of air, initially at 200oC, 1 bar. During an interval of 10 minutes, the paddle wheel transfers energy to the air at a rate of 1 kW.

What do larger horsepower engines require

What is a split wired receptacle

Consider two different flows over geometrically similar airfoil shapes, one airfoil being twice the size of the other. The flow over the smaller airfoil has freestream properties given by T[infinity] = 200 K, rho[infinity] = 1.

Engineering Design:Question 5 If preparing for a taco party were done using the engineering design process, which statement would describe prototyping and testing? Select one: 1. Determining how many tortillas you need for the party. 2.

New Questions in Engineering

Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.

The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius

Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.

What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution

The controller can be considered the brain of closed loop system