you have a permanent magnet whit remanent induction. than you cut a piec of that magnet. if you put that piece back into permanent magnet will the remanent induction be the same it was in begining

How to cycle a cycle

Solar energy stored in large bodies of water, called solar pounds, is being used to generate electricity.

If the open circuit voltage of a circuit containing ideal sources and resistors is measured at 6 V, while the current through the short circuit across the circuit is 200 mA, what would be the power absorbed by an ideal current source, I_s =

Identify 3 distractions for young drivers and explain how you plan to minimize these distractions

We want to machine by turning this part on a CNC lathe with uncoated carbide tools in optimal condition. A long rod of Ø15 mm is used. Cite the sources and then calculate: 1) The depth of cut to produce Ø14mm in two equal passes.

Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.

The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius

Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.

What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution

The controller can be considered the brain of closed loop system