River models are used to study many different types of flow situations. A certain small river has an average width and depth of 65 ft and 7 ft, respectively, and carries water at a flow rate of 775 ft3 / s. A model is to be designed based on Froude number similarity so that the discharge scale is 250. At what width and flowrate would the model operate?
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “River models are used to study many different types of flow situations. A certain small river has an average width and depth of 65 ft and 7 ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
The boundary-layer thickness, δ, on a smooth flat plate in an incompressible flow without pressure gradients depends on the freestream speed, U, the fluid density, rho, the fluid viscosity, μ, and the distance from the leading edge of the plate, x.
Answers (1)
How does google translate work and why did they create it ... random and stupid question
Answers (1)
Ice dams are most directly related to: (A) the installation of soffit vents and ridge vents. (B) heated air in an uninsulated, unvented attic. (C) the addition of vent spacers in rafter bays. (D) a roof having gutters. (E) a house having gable vents.
Answers (1)
The engine of a 2000kg car has a power rating of 75kW. How long would it take (seconds) to accelerate from rest to 100 km/hr at full power on level road. Neglect drag and friction.
Answers (1)
Which of the following is a commonly used unit of refrigeration capacity? a) - Ton of refrigeration b) - kJ of refrigeration c) - kg of refrigeration d) - kN of refrigeration
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)