Why might the 1990 earthquake and volcanic eruption in Luzon be related?
A) Both earthquakes and volcanic eruptions are caused by plate tectonics and can
occur in patterns.
B) Earthquakes occur in San Francisco but not in Chicago.
C) Tectonic plates can form deep ocean trenches, such as the Mariana Trench in the Pacific Ocean.
D) On April 2, Mount Pinatubo sent an explosion of steam, water, ash, and rock into the air.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Why might the 1990 earthquake and volcanic eruption in Luzon be related? A) Both earthquakes and volcanic eruptions are caused by plate ...” in 📙 Physics if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
What is the difference between density and specific gravity
Answers (1)
Water erosion occurs when water seeps into cracks or joints in rock and then freezes.
Answers (2)
A 0.002 kg arrow with an acceleration of 7.2 m/s2 is flying towards its target. How much force was exerted on the arrow? a. 0.0036 N b. 0.0052 N c. 0.0102 N d. 0.0144 N
Answers (2)
Which of the following is an example of a force? A. push B. pull C. inertia D. both A and B E. all of the above
Answers (1)
What can you infer about copper and sliver based on their position relative to each other on the periodic table?
Answers (2)
New Questions in Physics
Show your conversions on the right 8500 mm 2. 250 mg 3. 500000 g 4. 201 = 5. 0.5 Km 6. 350 mm
Answers (1)
As one goes from left to right in a period, which of the following is true? A. The number of protons decreases. B. The number of valence electrons increases. C. both A and B D. none of the above
Answers (1)
Which phrases describe organisms that formed index fossils
Answers (1)
What will happen to plant height if the amount of available light is reduced due to global dimming? Which type of investigation would most likely be conducted to answer the following question?
Answers (1)
A machine has an efficiency of 80%. How much work must be done on the machine so to make it do 50,000 J of output work?
Answers (1)