Why is it inadvisable to make a horseshoe magnet from a flexible material? 1. a flexible material is not easily magnetized. 2. a flexible material is easily loses its magnetism. 3. none of these 4. the poles of the magnet attract each other and will cause the magnet to bend. 5. a flexible material cannot be easily made into a horseshoe shape?
Answers (2)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Why is it inadvisable to make a horseshoe magnet from a flexible material? 1. a flexible material is not easily magnetized. 2. a flexible ...” in 📙 Physics if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
The magnetic flux through each loop of a 75-loop coil is given by (8.8t-0.51t3) * 10-2t⋅m2, where the time t is in seconds.
Answers (1)
The air pushes against the balloon with a force of 200 N and the area of the balloon is 2 m2. Calculate the Pressure.
Answers (1)
A student observed a sample of water in three states of matter. The student should describe the liquid water as a state of matter that has A. less kinetic energy than the solid state. B. less volume than the solid state. c.
Answers (1)
Two enery converrsation that take place when you warm a cup of cocoa in a microwave Oven
Answers (1)
A block with m = 300 grams oscillates at the end of a linear spring with k = 6.5 N/m. (assume this is a top-down view and the block is sliding on a frinctionless surface;
Answers (1)
New Questions in Physics
Between steps 3 and 4, the heat energy in the steam is converted to A. mechanical energy B. heat energy C. transitional energy D. electrical energy
Answers (2)
A steam engine absorbs 4 x 105 J and expels 3.5 x 105 J in each cycle. What is its efficiency? 100% 12.5% 75% 33%
Answers (1)
The Biot-Savart force law deals specifically with: a/the magnetic field surrounding a long, straight wire b / currents induced in a conductor c / the duplication of poles in a bisected bar magnet d / the force between magnetic poles
Answers (1)
If the efficiency of a lever is 30% and 560 J is used to move the lever, what is the work output? A) 18.7J B) 168 J C) 1,867 J D) 16,800 J
Answers (1)
What likely happens to the hart rate as the cardiac mucle gets stronger
Answers (1)