Ask Question
7 May, 18:52

Engineering stress and strain are calculated using the actual cross-sectional area and length of the specimen. True or false?

+2
Answers (1)
  1. 7 May, 18:57
    0
    False

    Explanation:

    True stress and strain are what are calculated by diving applied load by actual cross sectional area and change in length by length of specimen respectively. However, for engineering stress and strain, we use original area and original length. Generally, engineering Stress is always greater than the corresponding True Stress because the actual area increases due to Poisson's effect. Poisson's ratio is a measure of the Poisson effect, that describes the expansion of a material in directions perpendicular to the direction of compression. The value of Poisson's ratio is the negative of the ratio of transverse strain to axial strain.
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Engineering stress and strain are calculated using the actual cross-sectional area and length of the specimen. True or false? ...” in 📙 Social Studies if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers