Sign In
Ask Question
Chemistry
Jolie Harper
8 September, 05:19
What is the molarity of NO-3 in 0.160M KNO3?
+5
Answers (
1
)
Sara Roach
8 September, 06:55
0
In reality there is np conservation of concentration but in this case, since the volume is constant therefore we can say that we can balance concentrations.
Since we have 1 mol og NO3 per mole of KNO3, therefore we can say that for every 0.160M of KNO3 we can also have 0.160M of NO3.
Comment
Complaint
Link
Know the Answer?
Answer
Not Sure About the Answer?
Get an answer to your question ✅
“What is the molarity of NO-3 in 0.160M KNO3? ...”
in 📙 Chemistry if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
How much heat is needed warm 65.34 g of water from 18.43 to 21.75
Answers (1)
How do I balance this equation? Fe2O3 + C → Fe + CO2
Answers (2)
A square painting has a length of 62 cm. What is the area of the painting? cm²
Answers (1)
Under identical conditions of temperature, number of moles, and pressure, which of the following gases has the highest density: Ne, CO2, or Cl2?
Answers (1)
The bonding of two atoms will most likely occur if: A.) a more stable state can result from the union B.) the outer shell can be completely filled C.) all the valance electrons are removed D.) the electronegativity of both atoms are similar
Answers (1)
New Questions in Chemistry
Which set of factors changes igneous or sedimentary rock into metamorphic rock? heat and weathering water and weathering heat and pressure water and pressure
Answers (1)
What is the standard cell potential (E°cell) for the voltaic cell based on the reaction below? Sn2 + (aq) + 2Fe3 + (aq) → 2Fe2 + (aq) + Sn4 + (aq)
Answers (1)
G oil of wintergreen, c8h8o3 is prepared when methanol, ch3oh, is reacted with salicylic acid, c7h6o3. what is the percent yield of a reaction in which 15.3 g of oil of wintergreen is collected after 16.
Answers (1)
How can a neutral atom become a positively-charged particle?
Answers (1)
Mineral oil can be used in place of mercury in manometers when small pressure changes are to be measured. What is the pressure of an oxygen sample in mm of mineral oil if its pressure is 28.5 mm Hg? (d of mineral oil = 0.88 g/mL; d of Hg = 13.
Answers (1)
Home
»
Chemistry
» What is the molarity of NO-3 in 0.160M KNO3?
Sign In
Sign Up
Forgot Password?