A vehicle fails an HC emission test at idle and 2,500 rpm, and the engine has an acceleration stumble. The heated oxygen sensor (HO2S) voltage is 0.1-0.3 volts on a scan tool, and the injector pulse width is high. No diagnostic trouble codes (DTCs) are found. When propane is directed into the air intake, HO2S voltage immediately increases and the injector pulse width decreases. The most likely cause of this problem is
A. a defective O2 sensor.
B. a defective powertrain control module (PCM).
C. low fuel-pump pressure.
D. an opening in the O2 sensor signal wire.
+2
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “A vehicle fails an HC emission test at idle and 2,500 rpm, and the engine has an acceleration stumble. The heated oxygen sensor (HO2S) ...” in 📙 Computers & Technology if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Home » Computers & Technology » A vehicle fails an HC emission test at idle and 2,500 rpm, and the engine has an acceleration stumble. The heated oxygen sensor (HO2S) voltage is 0.1-0.3 volts on a scan tool, and the injector pulse width is high.