Ask Question
EngineeringEngineering
8 February, 04:40

While having a discussion about O-rings at the bottom of filters, Technician A says that the Automotive Filter Manufacturers Council recommends that the filter O-ring be lubricated with oil after installing the filter. Technician B says that the filter O-ring should be lubricated before installation. Who is correct

+1
Answers (1)
  1. 8 February, 07:25
    0
    Technician B is correct

    Explanation:

    O - rings are used with oil transmission filters to avoid transmission failures but some people use lip seals as well. either of them is inserted onto the outer part of the transmission system i. e it is inserted/found in-between Transmission filters and the transmission systems and it main purpose is to avoid leaks and transmission failure in the short and long term.

    0-rings should be lubricated before installation this is because the o-rings are usually super tight when installing and would require lubrication to ease the installation process else the rubber might get ruptured and this would lead to instant transmission failure.
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “While having a discussion about O-rings at the bottom of filters, Technician A says that the Automotive Filter Manufacturers Council ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Two common message delivery metrics that measure how much of the target market is exposed to the advertisement and the number of times they are exposed are:
Answers (1)
Health Maintenance Organizations (HMOs) are the new model for providing medical care. Criticisms of HMOs include all of the following except: a. big salaries for administrators. b. overemphasis on profit instead of care. c.
Answers (1)
An undeformed specimen of some alloy has an average grain diameter of 0.04 mm. You are asked to reduce its average grain diameter to 0.010 mm. Is it possible? If so, explain the procedure you would use to and the name the processes involved.
Answers (2)
Hope fixes her mistakes and comes up with this list. She thinks it is a good idea to list the gases based on the amount of the gas found in the atmosphere from largest to smallest percentage.
Answers (1)
A completely reversible heat pump produces heat at a rate of 100 kW to warm a house maintained at 25℃. The exterior air, which is at 0℃, serves as the source.
Answers (1)
New Questions in Engineering
Though still is on the margins of the global agro-food system, organic farming practices are on the rise in the core. In growing crops and raising livestock organically, which of the following are permitted? composted cow manure
Answers (1)
Technician A says that a magnetic field can be created by current flow. Technician B says that current can be induced by moving a wire through a magnetic field. Who is right?
Answers (1)
9.17 LAB: Name format Many documents use a specific format for a person's name. Write a program whose input is: firstName middleName lastName, and whose output is: lastName, firstName middleInitial.
Answers (1)
16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.
Answers (1)
The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder
Answers (1)
Home » Engineering » While having a discussion about O-rings at the bottom of filters, Technician A says that the Automotive Filter Manufacturers Council recommends that the filter O-ring be lubricated with oil after installing the filter.
Sign Up Forgot Password?