The strut is glued to the horizontal member at surface AB. If the strut has a thickness of25 mm and the glue can withstand an average shear stress of 600 kPa, determine the maximum force P that can be applied to the strut.

Discuss four (4) energy saving methods for having air conditioner installed in the house.

1 - A square-wave inverter has a dc source of 96 V and an output frequency of 60 Hz. The load is a series RL load with R = 5 Ohm and L = 100 mH.

A cylindrical hot water storage tank (see sketch) for a set of collectors is located in the basement of a dwelling. The tank is made of 0.080" thick steel and insulated with 3" thick fiberglass batt insulation.

This animation ends with a virus entering a host cell and its protein capsid degrading and releasing nucleic acid into the cell. What will occur next if this virus exhibits a lysogenic life cycle

Liquid ethanol (C2H5OH) at 298 K, 1 atm enters a steam generator operating at steady state and burns completely with dry air entering at 400 K, 1 atm. The fuel flow rate is 75 kg/s, and the equivalence ratio is 0.7.

Though still is on the margins of the global agro-food system, organic farming practices are on the rise in the core. In growing crops and raising livestock organically, which of the following are permitted? composted cow manure

Technician A says that a magnetic field can be created by current flow. Technician B says that current can be induced by moving a wire through a magnetic field. Who is right?

9.17 LAB: Name format Many documents use a specific format for a person's name. Write a program whose input is: firstName middleName lastName, and whose output is: lastName, firstName middleInitial.

16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.

The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder