Ask Question
EngineeringEngineering
6 March, 05:29

The manual clutch is normally mounted on which of the following components? A. Engine flywheel B. Transmission housing C. Differential D. Drive shaft

+5
Answers (1)
  1. 6 March, 07:01
    0
    Answer:A) Engine flywheel

    Explanation: Clutch is the part of the vehicles like car, motorbike etc that persist the property of the engaging and non-engaging of the engine from the wheels. Manual clutch is handled by the driver of the vehicle.

    The clutch is embedded on the flywheel which is a heavy device connected with engine. This part stores some amount of energy and works on the delivery of the power. Thus the correct option is option (a) as the other options are not the defined parts of the vehicle.
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “The manual clutch is normally mounted on which of the following components? A. Engine flywheel B. Transmission housing C. Differential D. ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
A certain working substance receives 100 Btu reversibly as heat at a temperature of 1000℉ from an energy source at 3600°R. Referred to as receiver temperature of 80℉, calculate: A. the available energy of the working substance (63 Btu) B.
Answers (1)
Steam enters a turbine operating at steady state at 800°F and 450 lbf/in^2 and leaves as a saturated vapor at 1.2 lbf/in^2. The turbine develops 12,000 hp, and heat transfer from the turbine to the surroundings occurs at a rate of 2 x 106 Btu/h.
Answers (1)
An insurance deductible is ... a commission paid to the agency for the purchase of a policy the monthly premium on an insurance policy. the contract fee applied to the monthly premium.
Answers (1)
The constant-pressure specific heat of air at 25°C is 1.005 kJ/kg·°C. Express this value in kJ/kg·K, J/g·°C, kcal / kg·°C, and Btu/lbm·°F. Round the final answers to three decimal place
Answers (1)
In measuring what does NEST stand for?
Answers (1)
New Questions in Engineering
The E7018 Electrode produces a/an
Answers (1)
Which is the correct order for handwashing
Answers (2)
You built an android that has a subcircuit containing a power supply, a tactile sensor, and a fuse where safe operation should keep current below 250 mA. You measured that your sensor is dissipating 12 W, the power supply is pro - viding 12.
Answers (1)
The electronics aboard a certain sailboat consume 50 W whenoperated from 12.6-V source. If a certain fully charged deep-cyclelead acid storage battery is rated for 12.
Answers (1)
The water behind Hoover Dam in Nevada is 221 m higher than the Colorado River below it. At what rate must water pass through the hydraulic turbines of this dam to produce 50 MW of power if the turbines are 100 percent efficient?
Answers (1)
Home » Engineering » The manual clutch is normally mounted on which of the following components? A. Engine flywheel B. Transmission housing C. Differential D. Drive shaft
Sign Up Forgot Password?