Hot water (cph = 4188 J/kg·K) with a mass flow rate of 2.5 kg/s at 100°C enters a thin-walled concentric tube counterflow heat exchanger with a surface area of 23 m2 and an overall heat transfer coefficient of 1000 W/m2 ·K. Cold water (cpc = 4178 J/kg·K) with a mass flow rate of 5 kg/s enters the heat exchanger at 20°C. Determine
(a) the heat transfer rate for the heat exchanger and
(b) the outlet temperatures of the cold and hot fluids. After a period of operation, the overall heat transfer coefficient is reduced to 500 W/m2 ·K, so determine
(c) the fouling factor that caused the reduction in the overall heat transfer coefficient.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Hot water (cph = 4188 J/kg·K) with a mass flow rate of 2.5 kg/s at 100°C enters a thin-walled concentric tube counterflow heat exchanger ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
What do you understand by the term redundant work?
Answers (1)
Glass-ceramic is a fine-grained crystalline ceramic formed by the controlled crystallization of a ceramic. (True, False)
Answers (1)
An alloy fin with a thermal conductivity of 200 W/ሺm ∙ Kሻ has a length of 2.5 cm and a thickness of 3.5 mm. The base of the fin is held at 400o C and the ambient is at 20o C.
Answers (1)
The concept of the "selective incorporation" supports which of the following principles of government? Representative Democracy O Rule of Law O Federalism O Majority Rule with Minority Rights
Answers (1)
Define full and partial well abandonment.
Answers (1)
New Questions in Engineering
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
What is the main role of matrix in composites! a) - to transfer stress to the other phases b) - to protect phases from environment c) - to reduce the hardness d) - to enhance ductility
Answers (1)