Which statement concerning symbols used on plans is true?
O Only carpenters use symbols.
O The same symbols are used thoroughout the world.
O
The symbols are to be noted on the title sheet or other introductory sheet of the plans.
O Symbols are never replaced by keynotes.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Which statement concerning symbols used on plans is true? O Only carpenters use symbols. O The same symbols are used thoroughout the world. ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Select the statement that is false. A. If two graphs G and H are isomorphic, then they have the same total degree. B. If two graphs G and H have the same degree sequence, then G and H are isomorphic. C.
Answers (1)
Paul is constructing an aquarium. The exterior of the aquarium in made of white marble. Which design principle element is being referred to in this scenario? A space OB. shape
Answers (1)
if you're disassembling a master cylinder and the front piston assembly is stuck in the master cylinder you can
Answers (1)
Technician A says that after replacing a power steering hose, the system should be flushed, refilled, and bled. Technician B says to replace any O-rings when installing a new hose. Who is correct? A. Technician A only B. Technician B only C.
Answers (1)
A common procedure for measuring the velocity of an air stream involves insertion of an electrically heated wire (called a hot-wire anemometer) into the air flow, with the axis of the wire oriented perpendicular to the flow direction.
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)