Reducing embodied energy for bricks requires: Select one: a. no drying of bricks before firing. b. using cement instead of clay. c. including wood fibers in the mix. d. firing at a lower temperature. e. using fly-ash and steam curing.

Carbon resistors often come as a brown cylinder with colored bands. These colored bands can be read to determine the manufacturer's target resistance value. The first two bands (L and M) represent the number.

What's a trade off? What is one trade-off that the New Balance management makes?

According to the zeroth law of thermodynamics, which of the following cannot occur? a) a room being heated by an air conditioner b) a temperature below the coldest item in an area c) a cooler full of ice chilling a soda sitting on top of it d)

The term motion refers to a change in position with respect to a. a specific reference b. the ground c. the center of the Earth d. the Sun

If 230 VDC is applied to a motor with a resistance of 10 ohms, how much current would be drawn?

16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.

The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder

What factors are likely to promote the formation of stress corrosion cracks?

Find the mass if the force is 18 N and the acceleration is 2 m/s2

Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion