Sign In
Ask Question
Engineering
Charlize Swanson
10 September, 10:32
What are the functions of a gear
+4
Answers (
2
)
Tyrese Guerrero
10 September, 12:02
0
It's engineering gnzvxhfhbkchufkh
Comment
Complaint
Link
Aldo
10 September, 13:11
0
Gear is used in the cars to speed up. It is used with the combination of clutch so that the tyres are ready to speed up.
Comment
Complaint
Link
Know the Answer?
Answer
Not Sure About the Answer?
Get an answer to your question ✅
“What are the functions of a gear ...”
in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
a metal coin has certain properties that can be measured. which property of a coin is different on the moon that is on earth?
Answers (1)
Can you tell me important facts about Peggy A. Whitson?
Answers (1)
Air enters a 30-cm-diameter cooling section at 1 atm, 35°C, and 45 percent relative humidity at 18 m/s. Heat is removed from the air at a rate of 750 kJ/min.
Answers (1)
Which of the following describes boundaries? (1) Boundaries are primarily used to indicate which functions a user will perform as opposed to the functions that a product will perform.
Answers (1)
When using the separatory funnel; which of the following are important Group of answer choices Shake vigorously to emulsify the two layers. The aqueous layer is always on the bottom. Use a ring clamp to hold the separatory funnel. Vent several times.
Answers (1)
New Questions in Engineering
16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.
Answers (1)
The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder
Answers (1)
What factors are likely to promote the formation of stress corrosion cracks?
Answers (1)
Find the mass if the force is 18 N and the acceleration is 2 m/s2
Answers (2)
Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion
Answers (1)
Home
»
Engineering
» What are the functions of a gear
Sign In
Sign Up
Forgot Password?