An engineering drawing shows the: (A) dimensions, tolerances, cost, and sales or use volume of a component. (B) dimensions, tolerances, materials, and finishes of a component. (C) materials, finishes, machining operations, and dimensions of a component. (D) cost, materials, tolerances, and lead-time for a component. (E) cost, dimensions, and machining operations for a component.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “An engineering drawing shows the: (A) dimensions, tolerances, cost, and sales or use volume of a component. (B) dimensions, tolerances, ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Brian is responsible for ordering cement for a construction project. He had just determined that the construction crew would need 540 cubic yards of cement when the building owner decided to shorten the driveway, eliminating the need for 44 cubic
Answers (2)
Consider a vertical piston/cylinder system. The piston has a mass of 35 kg and has an unknown radius. There is a pressure gauge to output the pressure inside the cylinder. If the piston is compressed and the pressure gauge reads 300 kPa.
Answers (1)
Convection ovens operate on the principle of inducing forced convection inside the oven chamber with a fan. A small cake is to be baked in an oven when the convection feature is disabled.
Answers (1)
Choose the correct statement. A. A firm's minimum efficient scale is the smallest quantity of output at which long-run average cost reaches its lowest level. B. A firm's minimum efficient scale increases when the number of people employed increases.
Answers (1)
Can someone explain how an LED works?
Answers (2)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)