Ask Question
EngineeringEngineering
24 September, 18:28

A finished, tapered workpiece has an included angle of 70 degrees. If the taper is nade vith the compound, how many degrees should tha setting be on the swivel base? A. 70 B. 140 C. 20 D. 35

+4
Answers (1)
  1. 24 September, 20:43
    0
    Tapering is basically the process of thinning or reducing a work piece according to the set standards. and the final product after tapering is known as tapered workpiece.

    Solution:

    Included angle = 70 degrees

    setting on the swivel base is given by:

    2α = 70°

    α = 35°

    Therefore, the setting on the swivel base should be 35°
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “A finished, tapered workpiece has an included angle of 70 degrees. If the taper is nade vith the compound, how many degrees should tha ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Takt time is the rate at which a factory must produce to satisfy the customer's demand. a) - True b) - False
Answers (1)
In cell M2, enter a formula using a nested IF function and structured references to determine first if a staff member already has completed leadership training, and if not, whether that staff member is eligible for leadership training.
Answers (1)
Steam enters and leaves a horizontal 1D pipe steadily at a constant speed with the specific enthalpy to be 4000 kJ/kg and 1500 kJ/kg respectively. Assuming a mass flow rate of 0.
Answers (1)
Once Joe Martin reports his concerns to senior management at corporate headquarters and requests that the Ethicana plant operations be suspended until the faulty equipment, safety and operational issues are corrected it would be unethical for Joe to
Answers (1)
Water is the working fluid in an ideal Rankine cycle. The pressure and temperature at the turbine inlet are 1200 lbf / in^2 and 1100°F, respectively, and the condenser pressure is 140 lbf/in^2 The mass flow rate of steam entering the turbine is 1.
Answers (1)
New Questions in Engineering
Mobo, a wireless phone carrier, completed its first year of operations on October 31. All of the year's entries have been recorded, except for the following: a.
Answers (1)
1. Research has found that lap/shoulder safety belts, when used, reduce the risk of fatal injury to front-seat passenger car occupants by percent. A. O 25 B. O 35 C. O 45 D. O 55
Answers (2)
When an emergency vehicle approaches you from in front or behind you, what should you do?
Answers (1)
The surface energy of a single crystal depends on crystallographic orientation. Does this surface energy increase or decrease with an increase in planar density
Answers (1)
5. If a pilot wants to accelerate, which force needs to increase? a. drag b. lift C. thrust d. weight
Answers (1)
Home » Engineering » A finished, tapered workpiece has an included angle of 70 degrees. If the taper is nade vith the compound, how many degrees should tha setting be on the swivel base? A. 70 B. 140 C. 20 D. 35
Sign Up Forgot Password?