Ask Question
EngineeringEngineering
13 May, 14:07

Increasing rake angle will decrease the tendency for Built-Up-Edge to form. a) True b) False

+1
Answers (1)
  1. 13 May, 16:14
    0
    a) True

    Explanation:

    While machining of ductile material and high feed and low cutting speed welding action take place between tool material and chip material this welding action is called built up edge. Built up edge action takes place due to high temperature.

    To decrease the built up edge action

    1. Increase the rake angle.

    2. Increase the cutting speed

    3. Decrease the feed rate

    4. Use cutting fluid
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Increasing rake angle will decrease the tendency for Built-Up-Edge to form. a) True b) False ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
A transmission line with an imperfect dielectric is connected to an ideal time-invariant voltage generator. The other end of the line is open.
Answers (1)
Write multiple if statements: If carYear is before 1967, print "Probably has few safety features." (without quotes). If after 1970, print "Probably has head rests.". If after 1991, print "Probably has electronic stability control.".
Answers (1)
The profile height of the tire sidewall (from bead to tread) is 117 mm. The height of the rim is 381 mm. What is the total height of the rim and tire together?
Answers (2)
two forces act at 60 degrees and their resultant is 14 neutons, if they act at 90 degrees their resultant is 90 degrees. find the mangitude of forces?
Answers (1)
Wheel diameter = 150 mm, and infeed = 0.06 mm in a surface grinding operation. Wheel speed = 1600 m/min, work speed = 0.30 m/s, and crossfeed = 5 mm. The number of active grits per area of wheel surface = 50 grits/cm2.
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
Home » Engineering » Increasing rake angle will decrease the tendency for Built-Up-Edge to form. a) True b) False
Sign Up Forgot Password?