Moist air enters a duct at 10 oC, 70% relative humidity, and a volumetric flow rate of 150 m3/min. The mixture is heated as it flows in the duct and exits at 40oC. No moisture is added or removed, and the mixture pressure remains approximately constant at 1 bar. For steady-state operation, determine (a) the rate of heat transfer, in kJ/min, and (b) the relative humidity at the exit. Change in kinetic and potential energy can be ignored.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “Moist air enters a duct at 10 oC, 70% relative humidity, and a volumetric flow rate of 150 m3/min. The mixture is heated as it flows in the ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Water flows at 5 Liters/s through a horizontal pipe that narrows smoothly from 10 cm diameter to 5 cm diameter. A pressure gauge in the narrow section reads 50 kPa. What is the reading of the pressure gauge in the wide section
Answers (1)
When a group of engineers conduct a trial launch of a new rocket, the rocket explodes on the launchpad. What should the engineers do next? O A. Add a new functionality to the rocket, such as a GPS tracking system. O B.
Answers (1)
An automobile engine provides 632 Joules of work to push the pistons and generates 2203 Joules of heat that must be carried away by the cooling system. Calculate the change in the internal energy of the engine. E
Answers (2)
Which of the following is the best way to prevent poor user orientation in a website? O avoiding multiple competing navigation menus labeling all pages with meaningful titles including a search feature on large sites including a comprehensive site
Answers (1)
James is planning on registering for a course in electrical engineering. Which of the following sub disciplines could he opt for?
Answers (1)
New Questions in Engineering
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
What is the main role of matrix in composites! a) - to transfer stress to the other phases b) - to protect phases from environment c) - to reduce the hardness d) - to enhance ductility
Answers (1)