Sign In
Ask Question
Engineering
Trevin Everett
26 September, 21:38
Define drag and lift forces.
+5
Answers (
1
)
Rogelio
26 September, 23:07
0
Drag is the force which is generated parallel and also in opposition to direction of the travel for the object which is moving through the fluid.
Lift is the force which is generated perpendicular to direction of the travel for the object moving through the fluid.
Both of the two forces which are the lift and the drag force act through center of the pressure of object.
Comment
Complaint
Link
Know the Answer?
Answer
Not Sure About the Answer?
Get an answer to your question ✅
“Define drag and lift forces. ...”
in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
In an ideal Otto cycle, indicate whether the following statements are true or false: (A) All the processes are internally reversible. (B) Cycle efficiency increases with the maximum temperature.
Answers (1)
A structural component in the shape of a flat plate 24.2 mm thick is to be fabricated from a metal alloy for which the yield strength and plane strain fracture toughness values are 545 MPa and 20.0 MPa-m1/2, respectively.
Answers (1)
Determine the enthalpy, volume and density of 1.0 kg of steam at a pressure of 0.5 MN/m2 and with a dryness fraction of 0.96
Answers (1)
A composite wall is to be used to insulate a freezer chamber at - 350C. Two insulating materials are to be used with conductivities of 0.04 W/mK and 0.1 W/mK. If the outside surface temperature of the inner layer (0.
Answers (1)
A steel bar 100 mm long and having a square cross section 20 mm on an edge is pulled in tension with a load of 89,000 N and experiences an elongation of 0.10 mm.
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)
Home
»
Engineering
» Define drag and lift forces.
Sign In
Sign Up
Forgot Password?