To increase fault-tolerance, the security administrator for Corp has installed an active/passive firewall cluster where the second firewall is held in reserve in case of primary firewall failure. Stateful firewall inspection is being used in the firewall implementation. There have been numerous reports of dropped connections with external clients. Which of the following is MOST likely the cause of this problem?
(A) All packets are traversing the passive firewall causing the connections to be dropped.
(B) The heartbeat between the firewalls is not enabled.
(C) Inbound packets are traversing the active firewall and return traffic is being sent through the passive firewall.
(D) All packets are traversing the active firewall causing the connections to be dropped.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “To increase fault-tolerance, the security administrator for Corp has installed an active/passive firewall cluster where the second firewall ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
What is the purpose of guarding electrical equipment with exposed parts operating at 50 volts or more? Select the best option.
Answers (1)
10.1. Agency theory has been criticized for assuming that managers, left on their own, will behave in ways that reduce the wealth of outside equity holders when, in fact, most managers are highly responsible stewards of the assets they control.
Answers (1)
The following questions present a twist on the scenario above to test your understanding. Suppose another stone is thrown horizontally from the same building. If it strikes the ground 67 m away, find the following values.
Answers (1)
Como se conecta un circuito eléctrico con dos o más resistencias en paralelo
Answers (1)
why is gamora ...
Answers (2)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)