Fixed objects that fix a location are called

8. What side length would you specify if you were required to create a regular hexagonal plate that was comprised of 33 cm - of sheet metal? Bonus: Sketch the hexagon, dimension the side length on the sketch to 0.1 cm, and indicate your grid spacing.

What are the weight restrictions for a small UAS, including everything onboard at the time of takeoff? (Circle the correct answer) (A) GTOW greater than. 55 lbs. and less than 55 lbs. B. GTOW greater than 5 lbs. and less than 50 lbs. on to fly a UAS.

Twenty degree C air enters a tube bank which is to be used to remove 150 [kW] of heat from condensing refrigerant. The refrigerant is flowing inside the tubes of the bank and causes the external tube surfaces to be maintained at 100o C.

Which of the following components of a PID controlled accumulates the error over time and responds to system error after the error has been accumulated? a) - Proportional b) - Derivative c) - Integral d) - ON/OFF.

In response to the market revolution:the legal system worked with local governments to find better ways to regulate entrepreneurs.

16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.

The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder

What factors are likely to promote the formation of stress corrosion cracks?

Find the mass if the force is 18 N and the acceleration is 2 m/s2

Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion