A capillary tube is immersed vertically in a water container. Knowing that water starts to evaporate when the pressure drops below 2 kPa, determine the maximum capillary rise and tube diameter for this maximum-rise case. Take the contact angle at the inner wall of the tube to be 6° and the surface tension to be 1.00 N/m.
Answers (1)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “A capillary tube is immersed vertically in a water container. Knowing that water starts to evaporate when the pressure drops below 2 kPa, ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
What is clearance? What is backlash? What is interference? Explain briefly.
Answers (1)
The pulley has mass 12.0 kg, outer radius Ro=250 mm, inner radius Ri=200 mm, and radius of gyration kO=231 mm. Cylinder A weighs 71.0 N. Assume there is no friction between the pulley and its axle and that the rope is massless.
Answers (1)
Describe harmful effect associated with extraction of Aluminum, Gold and Copper. Discuss each individually.
Answers (1)
Part of a good computer posture is to sit up straight with feet flat on the floor t or f
Answers (1)
Technician A says that load-carrying ball joints should always have some play in them. Technician B says that follower ball joints should never have some play in them. Who is correct? a. Technician A b. Technician B c. Both A and B d.
Answers (1)
New Questions in Engineering
Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.
Answers (1)
The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius
Answers (1)
Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.
Answers (1)
What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution
Answers (1)
The controller can be considered the brain of closed loop system
Answers (1)