For an open channel with a given slope, if the roughness is decreased

a. The flow rate in the channel will increase

b. The flow rate in the channel will remain the same

c. The flow rate in the channel will decrease

1. The type of ignition system in which two cylinders share one coil is called a: a. distributor ignition system. b. waste spark ignition system. c. coil-on plug ignition system. d. None of the above

You want a pot of water to boil at 105celcius. How heavy a lid should you put on the 15 cm diameterpot when Patm = 101 kPa?

Write down the duty of the Accumulators?

A solid square rod is cantilevered at one end. The rod is 0.6 m long and supports a completely reversing transverse load at the other end of + / - 2 kN. The material is AISI 1080 hot-rolled steel.

Which actions would the maintenance and operations crews carry out as a building is completed and preparing to open to the public? Select all that apply.

Familiarity with basic fastener properties: For each of the standard fasteners specified informally below, determine the major diameter d, the pitch p, the pitch diameter dp, and the bolt length L.

The diameter of a cylinder is called the a.) stroke b.) bore c.) principal length d.) radius

Consider the following grooves, each of width W, that have been machined from a solid block of material. (a) For each case obtain an expression for the view factor of the groove with respect to the surroundings outside the groove.

What is the last step to the design process? A: Define the problem B: Present solution C: Evaluate a solution D: Develop a solution

The controller can be considered the brain of closed loop system