Ask Question
1 November, 18:49

What is the effect of increasing rake angle on the type of chips produced, and why?

+1
Answers (1)
  1. 1 November, 19:19
    0
    There are two rake angle types:

    Positive rake

    This is the case that occurs when looking from the inner side the face of the cutting tool slopes away from the cutting edge.

    Negative rake

    This is the case that occurs when the face of the cutting tool slopes away from the cutting edge at the outer side.

    Increasing the positive rake angle means that the cutting tool will get sharper thus making the tool weaker. So, brittle material will form discontinuous chips and ductile material will form continuous chip. The tool life may also be reduced.

    Increasing the negative rake angle means that the cutting tool will get blunt thus making the tool stronger. So, brittle material will form continuous chips. Results in higher temperature of the tool. Surface finish might increase.
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “What is the effect of increasing rake angle on the type of chips produced, and why? ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers