liquid water enters a cooling tower operating at a steady state 40ºC with a mass flow rate of 105 kg/h. Cooled water at 25ºC exits the cooling tower at the same mass flow rate. Makeup water is supplied at 23ºC. Atmospheric air enters the tower at 30ºC, 1 bar, 35% relative humidity. A saturated moist air stream exits at 34 ºC, 1 bar. Determine a. the mass flow rates of the dry air and makeup water, each in kg/h. b. teh rate of exergy destruction within the cooling tower, in kW, for T0 = 23ºC
Answers (2)
Know the Answer?
Not Sure About the Answer?
Get an answer to your question ✅ “liquid water enters a cooling tower operating at a steady state 40ºC with a mass flow rate of 105 kg/h. Cooled water at 25ºC exits the ...” in 📙 Engineering if there is no answer or all answers are wrong, use a search bar and try to find the answer among similar questions.
Search for Other Answers
You Might be Interested in
Ben is surveying a plot to build a road 5 km long. how many meters long will the road be?
Answers (1)
a metal coin has certain properties that can be measured. which property of a coin is different on the moon that is on earth?
Answers (1)
g Assume a base, Base has a derived class, Sub ... Also, assume a method called methodX () is defined in Base and overridden in Sub.
Answers (1)
An irreversible heat pump and a Carnot heat pump operate between the same two thermal reservoirs. Which heat pump has higher COP?
Answers (1)
A 5,000 kg satellite is orbiting at 900 km above the Earth's surface. What is the potential energy of the satellite? At what distance from the Earth's surface is a 10,000 kg satellite if its potential energy is equal to - 4.68 x 10 11 J?
Answers (1)
New Questions in Engineering
16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.
Answers (1)
The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder
Answers (1)
What factors are likely to promote the formation of stress corrosion cracks?
Answers (1)
Find the mass if the force is 18 N and the acceleration is 2 m/s2
Answers (2)
Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion
Answers (1)