150 lb of force is applied at the end of a shaft that is 2 1/2 ft long. It is applied

at an angle of 90° to the lever. How much torque is produced? If the shaft is

rotating at 350 rpm, what is the power?

Which of these may be an abnormalitu during your pre drive check a) there is another vehicle nearby b) your mirrors are aligned c) the steering wheel responds d) theres an unidentified puddle

If i see i dead army person will i be asked questions and if i see the person who did it

2. Sometimes? are too great for a family to deal with alone

6.17 (Even or Odd) Write a method isEven that uses the remainder operator (%) to determine whether an integer is even. The method should take an integer argument and return true if the integer is even and false otherwise.

Consider a person standing in a breezy room at 20°C. Determine the total rate of heat transfer from the person if the exposed surface area and the average outer temperature of the person are 1.6 m2and 29°C, respectively.

16 Suppose that a steel of eutectoid composition is cooled to 550°C (1020°F) from 760°C (1400°F) in less than 0.5 s and held at this temperature.

The rotor in a shaded pole motor consists of A coils energized by alternating current B a short circuited loop of copper wire c a permanent magnet D an iron cylinder

What factors are likely to promote the formation of stress corrosion cracks?

Find the mass if the force is 18 N and the acceleration is 2 m/s2

Which process must first take place in order for the proteins in foods to be used by body cells? (1) digestion (3) synthesis (2) storage (4) excretion